类型: IC
作者:
BlindAssassin111
发布时间: 2018-02-14 21:58:58
更新时间:
2018-03-07 00:47:58
原链接:
https://geekhack.org/index.php?topic=94086.0
So I have been throwing an idea around about making
replacement PCBs for the omnikey ultra’s because when I
bought mine it had some corrosion and some pads have ripped
off of the PCB forcing me to use wire to replace the no
longer usable traces.
So I was thinking of designing a
pcb to be used with a teensy and a USB panel extension to
replace the original PCB and upgrade to USB as I don’t know
how to do PS/2 and would think more people would be in for
it if it where to be USB. Plus I don’t want to do SMD
soldering or pay to have them assembled that way as it would
complicate the design quite a bit.
Initial thoughts are
to Support the Ultra and Ultra T as they are the same PCB
just have 6 switches unoccupied on the Ultra T and a
different top cover. Also could support the non Ultras, but
would need to look into that a bit more.
I would like
to do a small run only as I have other projects I need to do
as well and this was a much quicker one to do as I can start
designing next week and open a GB fairly quickly.
MOQ
is going to probably be 10, including the one I will order.
Pricing is dependent on how many PCBs are wanted but they
will for sure be under $50, and drop in price very fast with
more orders, and can be half the cost at 40 PCBs, if pricing
works like I was quoted for another PCB I did.
Here is
the Form:
https://goo.gl/forms/JhwNVxaUeESEHnkc2
Hope this goes somewhere!!!
EDIT:
Also added support for ANSI and ISO layouts. Will supply a
plate file with the pcb so you can even make custom cases
for a fullsize or larger alps board. Check last post as GB
will be launching very soon!