类型: IC
作者: jebbra
发布时间: 2016-11-05 12:08:03
更新时间:
2017-05-17 02:45:29
原链接:
https://geekhack.org/index.php?topic=85663.0
SAMPLES & ANOUNCEMENT:
- This time only Case B will run
- Case A will run after Case B is 100% done (including shipping)
- Case B will require smaller plate, which will be supplied in the buy later. Or you can cut/file the OLKB plate (2.5mm on each side) like I did for these prototype. I don’t wanna widen the inner opening just to make it compatible to unmodified OLKB plate because it will make the gap between keycaps and case too wide especially compared to between keycaps, and that’s against my design believe. And I can’t make it 2 parts like KMAC did too because the small width the bezel has (and KMAC’s plate have its own screw hole too).
-
Case A will be redesigned to support unmodified OLKB plate
by dividing it to 2 parts, Top Case and Bottom Case. The
wide bezel on this case allowed the screw post to be
implemented. Splitting it to 2 part design may increase
the price but I still don’t know yet because I want to
focus on the Case B 1st and develop the Case A further
after it (so for you who already soldered and love your
Planck, please add some extra patient in the waiting time
).
Case A
Case B
A high profile metal (still searching for available material) for Planck.
The thing about hipro case on Planck is it will look awkward in proportion because the nature size of Planck.
So to give an impression of slimmer case I make 2 designs, one inspired from Apple M0110A Keyboard and the other is inspired by Apple MacBook White Polycarbonate.
Please fill this form >>> https://goo.gl/forms/shPLUsCtqkxoOwyD2 <<<
If you like to get email notification regarding major update on this case!
Updated Case A (Apple M0110A)
Updated Case B (MacBook Polycarbonate)
I still working on the inner part for now, mimicking the original architecture of Planck milled case.
Update 1
Got a render for Case B
Current status:
Revising 1st samples / Searching for coating vendor
Next move:
Get total quotation
Yay or nay?