类型: IC
作者:
nubbinator
发布时间:
2015-04-01 22:02:56
更新时间: 2015-04-01 22:02:56
原链接:
https://geekhack.org/index.php?topic=70556.0
I’m still working on my prototypes to see if the model is
viable, but before I go any further, I wanted to see if
anyone else was interested.
I have both Tactile and
Linear Hi-Tek switches, no Clicky.
Metal 3D printed:
These won’t be cheap. In simple steel versions, the
price ranges from $30-35 just for the printing, not counting
the switch, any included accessories, and shipping. It might
get cheaper if multiple holders are made at the same time
(it generally is), but I can’t say what kind of price
difference it would be yet. I wouldn’t trust other plastic
materials, but the ones that can print in acceptable
tolerances are half the price if you wanted to give them a
shot.
Laser Cut/Water Cut/CNCed
The cost of this is highly contingent upon material,
cutting method, and finish (if applicable). Acrylic would be
the cheapest while powder coated steel or anodized aluminum
would add a bit to the cost even if the middle were to
remain acrylic. If the middle isn’t acrylic, the middle
piece would likely have to be waterjet cut or milled due to
the thickness.