类型: IC
作者: wcass
发布时间: 2014-05-18
14:53:16
更新时间: 2014-05-18 15:11:42
原链接:
https://geekhack.org/index.php?topic=58437.0
A part of my Kishsaver that is not in great condition is the
feet. On my KS, the two front feet are OK, but the back two
are deformed - squashed flat. I think that the keyboard
might have been riveted into a keyboard tray. Anyway, I was
thinking about casting new feet.
I have lots of choices
for mold making - the cheap stuff makes lower detail
castings and is only good for very few castings - expensive
molds usually last longer and have better detail. So, I need
to know if I will be making feet for just myself, or for the
whole lot of you guys with Kishsavers. My goal is to keep
the cost under $10 to replace all 4. I may need help
modeling this, so if you have the skill and software, let me
know.
The shape of the feet is like a rectangular
grommet - 9mm x 9mm.
