类型: IC
作者:
kawaiicheung
发布时间: 2022-04-19 16:54:41
更新时间:
2022-04-19 17:02:58
原链接:
https://geekhack.org/index.php?topic=116965.0
S98 is very different from Master98 in appearance and
structural details.
The layout is exactly the same as the previous Master98,
and it still maintains a very compact layout. The row where
the ESC is located is the upper light position, and the
below 5 rows are the lower light position. The advantage of
this is to ensure the brightness effect of the top row of
lights. And the PCB is flex cut to ensure the typing feel.
The PCB is Bluetooth 5.2 dual-mode, hot-swappable, RGB
lights, RGB bottom lights, and music rhythms.
There is a foot on the back that is slightly larger than
the keyboard, and all the frame width ratios, including the
ratio of the foot to the overall length, seem to be
relatively harmonious. There are three indicator lights
between ESC and F1 in the upper left corner. With the
indicator light, there are three decorative lines running
through the whole and connecting to the side.
The USB interface is in the middle of the keyboard, and is
connected to the main PCB with a spring pin. Considering
that this kit is equipped with dual-mode Bluetooth as
standard, the USB interface and the Bluetooth power switch
are made on an independent small board and placed in
independent feet. There are also two 3000mah lithium
batteries installed in the feet, so there is a total of
6000mah power. The interface and the Bluetooth power supply
switch are separated from the main board by the
sub-interface board. For the overall structure and
experience of the assembly process, an adapter board is also
made between the interface board and the main PCB to realize
the transfer of the cable to the pin. When disassembling and
assembling, the two parts will not pull each other, which is
also a bit modular.
The support connection structure between the support
foot and the main body part of the bottom case is retracted
and a very thin one. It also integrates a small contact PCB
for connection to the motherboard. In this way, there is an
empty space above the feet. With the lighting of 30 RGB
bottom lights, my expectation is that this circle of feet
will show some sense of suspension. It is the feeling that
the feet and the main body are suspended in the air, and the
feet support the whole keyboard with its idea. The lighting
simulated by the rendering is a little stiff. I am still
looking forward to the specific effect of the physical
effect and I have to wait for more than a week for the PCB
sample. At first, my idea was that the RGB lights cooperate
with the opening of the casing to let the light through and
shine on the feet. In this case, the normal viewing angle
can only see some light reflected by the legs, but cannot
see the light source. However, the disadvantage is that the
light may be limited by the size of the opening, which is
relatively concentrated and not scattered. So I thought of
the glass beads that I used for the indicator light of
another keyboard before. There are some refraction lenses,
and the light will be more scattered. In addition, after
inlaying glass beads, you can still see the transparent
glass beads from a certain angle, which is also very
special.
In this Gasket structure, from top to bottom, there are
segmented thin poron pads between the top shell and the
positioning board, PC plate, 3.5mm thick overall poron
padding between the plate and the PCB, PCB, 2mm thickness
under the PCB of the overall poron padding.
Discord:
https://discord.gg/x3GTCeE
Instagram:
https://www.instagram.com/xikiimaker