类型: IC
作者:
ReDsNoTDeAd
发布时间:
2019-12-01 18:22:25
更新时间: 2020-03-03 11:35:20
原链接:
https://geekhack.org/index.php?topic=103635.0
Hi guys, this is going to be very simple for now, as I have
not started doing any design work on this, but I’m thinking
about redoing the ADK64 case with a top mount or gasket
mount.
Reasons:
- Tray mount sux
- FR4 plates enable me to do some whacky plate to fit a 2-piece 3d printed layout like the ADK18
- Printing the ADK64v2 in two halves means we get a really smooth curve like the ADK18
-
Its not tray mount, because tray mount sux
I’m leaning more towards top mount over gasket mount, as my other project (PLA75) was easy to implement gaskets into because it was built around them from the ground up, whereas this may be harder to implement because I’m limited to keeping the ADK64 shape. I’ll probably end up doing some clever burger mount with elastic bands or something nifty.
So yeah, let me know if you’re interested, let me know if I should run anything more than the grey/beige/clear/glow, and let me know general thoughts.
Since I’m doing a case and plate, I might as well offer a PCB too, and Nachie should be done his paladin64 redesign. As those with the paladinpad know, they’re quite nice, feature rich, and just good boards, so I’ll see if we can get a batch of those made.
Timeline is roughly this:
- Finish winter semester in one piece
- Do most of the design changes on the ADK64 over holiday break
- Prototyping in January
- GB sometime in Feb if everything goes right.